Spare Parts for QIDI Plus5 Accessories

Plus5 Chamber Heater with fan

The QIDI Plus 5 Heater with fan is responsible for heating the printer's print chamber to keep it at a constant temperature. This helps create a stable printing environment and prevents problems such as material warping or poor adhesion, especially when using temperature-sensitive consumables. It ensures that the print chamber is at an optimal temperature, resulting in high-quality printing.

Plus5 Hotend Cooling Fan

The Hotend Cooling Fan cools the hotend to avoid premature filament softening and clogs.

QIDI Plus5 Model Cooling Fan

The Part Cooling Fan, located at the toolhead's base, works in tandem with the Air Duct to swiftly cool extruded filament.

QIDI Plus5 Auxiliary Fan

The QIDI Plus5 Auxiliary Fan is a 4-Pin PWM Fan with RPM Feedback installed on the left side of the chamber, providing better cooling conditions for high-speed printing.

Plus 5 Camera

The camera is a low frame rate camera that enables remote live broadcast and time-lapse shooting.

Working Temperature:  -20°C to 70°C

Resolution Ratio: 1920*1080

Maximum Image Transfer Rate: 1-30fps

EFL: 2.3mm

FOV: 130°±15° 

F/No: 2.0

Plus 5 Bimetal Hotend

Unlocks High-Temp Printing up to 370°C.

Optimized for Reliable, High-Flow Extrusion.

Cautions for Use.

This accessory is compatible only with the Plus5. It is not compatible with other models. When replacing, ensure that the hotend cable clip is facing outward.

It is recommended to use only one type of filament in a single nozzle. Switching between multiple filaments in one nozzle may cause nozzle blockage.

Plus5 3-in-1 Air Filter

This 3-in-1 air purification component integrates G3 pre-filter, H12 HEPA filter and activated carbon filter, forming a full-range protection. G3 pre-filter blocks hair, dust and other large particles; H12 HEPA filter captures 99.5% of particles above 0.3μm, reducing printing dust diffusion; coconut activated carbon effectively absorbs VOCs and odors generated by heating PLA, ABS, PETG and other consumables.

Cautions for Use

Recommended replacement cycle: 500-800 hours of cumulative printing (shortened to 300-500 hours for high-dust consumables such as carbon fiber, nylon).