for Anycubic Photon P1 /P1 MAX NFEP Integrated Release Film

for Anycubic Photon P1 NFEP Integrated Release Film

The NFEP is suitable for Anycubic Photon P1 Resin Printer

Quick install, The release film comes with a ring, No need to disassemble the ring and cut the NFEP film. The entire installation process only takes 3 minutes. and there is an easy-to-follow tutorial on the package that guiding you to better replace the NFEP film.

As the NFEP release film is an consumable, regular replacement will make your printing effect better. If you have any questions, please feel free to contact us.

Resin 3D Printer:The FEP film is damaged or the end of expected usage life.

1. How to determine when to replace the FEP film

If the printer prompts that the usage life of the FEP film has expired, but the FEP film is not damaged, it is up to personal preference to decide whether to replace the FEP film.

If the printer prompts that the usage life of the FEP film has expired and the FEP film has been damaged (resin has leaked onto the screen), the FEP film must be replaced.

If the printer does not prompt anything, but the FEP film is damaged, the FEP film must also be replaced.

Note: This message indicates that the print count of the release film has reached its preset usage life. The NFEP release film and ACF release film are anticipated to have a usage life of approximately 30,000 layers, while the FEP release film is projected to last for about 10,000 layers. However, if the release film remains undamaged at this point, it is possible to choose not to replace it.

2. How to remove the resin on the screen

If cured resin is found on the LCD screen after removing the material tank, it is because the FEP film is damaged.

You can try wrapping the resin on the screen with a paper towel soaked in alcohol (which softens the resin), and then use a scraper to clean the resin off. Please be careful not to damage the screen while scraping.