Auxiliary Part Cooling Fan (Left) - P2S for Bambu Lab

The Auxiliary Part Cooling Fan (Left) is a powerful 12W cooling fan, which is an optional accessory. Installed on the left side of the chamber, it provides better cooling conditions for high-speed printing.

Installation

Please learn about the installation on Auxiliary Part Cooling Fan - Left - Installation Guide for the P2S | Bambu Lab Wiki

In the Box

- Auxiliary Part Cooling Fan - Left*1

Compatibility

P2 Series

Product Specifications

Auxiliary Part Cooling Fan - Left

The Auxiliary Part Cooling Fan (Left) is a powerful 12

W cooling fan, which is an optional accessory. Installed on the left side of the chamber, it provides better cooling conditions for high-speed printing.

When to Use this Guide

Damaged fan blades
Fan motor failure
Abnormal fan noise

Required Tools and Materials

1.Auxiliary Part Cooling Fan (Left)
2. H2.0 Allen key

Install Additional Auxiliary Part Cooling Fan - Left

Step 1：Lower the Heatbed

Tilt the printer, pull the Z belt to lower the heatbed, and fully expose the installation position of the auxiliary part cooling fan-left.

Step 2：Remove the Rear Panel

Please refer to this wiki to remove the rear panel: Rear Panel Replacement Guide for the P2S | Bambu Lab Wiki

Step 3：Install the Auxiliary Part Cooling Fan - Left

1. Peel off the protective paper from the double-sided tape on the fan;
2. Position the fan according to the stud locations and tighten three screws using an H2.0 Allen key.

   Step 4：Connect the Fan Cable

   1. Pass the fan cable through the gap between the side panel and the inner shelf;
   2. Connect the cable to the MC board.
   3. Manage the cable: Pull the cable from the MC board side, then attach the cable to the crossbeam.

      Step 5：Install the Rear Panel

      Please refer to this wiki to install the rear panel: 更换 P2S 背板 | Bambu Lab Wiki

      Remove the Auxiliary Part Cooling Fan - Left

      Step 1：Lower the Heatbed

      Tilt the printer, pull the Z belt to lower the heatbed, and fully expose the auxiliary part cooling fan.

      Step 2：Remove the Rear Panel

      Please refer to this wiki to remove the rear panel: Rear Panel Replacement Guide for the P2S | Bambu Lab Wiki

      Step 3：Disconnect the Auxiliary Part Cooling Fan Cable

      Disconnect the auxiliary part cooling fan cable from the MC board.

      Step 4：Remove the Auxiliary Part Cooling Fan Cable

      1. Use an H2.0 Allen key to remove the three screws that secure the fan;
      2. Then pull firmly to separate the fan (fixed with double-sided tape) from the side panel.
      3. Pull out the fan cable and remove the auxiliary part cooling fan.

         Verifying Success

         Connect the power cable and turn on the power. Tap the Auxiliary Part Cooling Fan icon on the screen to activate the auxiliary part cooling fan. If the auxiliary part cooling fan operates as expected, the replacement is complete.