Panda Touch User Manual
PANDA TOUCH Overview
* Slide the power switch to🔋 for Panda Touch to run on its lithium battery, enabling portability. Slide it to "DC 5V" for direct power from the magnetic charging dock, preserving the internal battery's lifespan. To "OFF" turns off Panda Touch.
CHARGING DOCK
*The power input has been outfitted with hot-plug protection, allowing users to hot-plug the power supply.
Packing List
Installation Instructions
1.installing Panda Touch
2. Wiringand Power connection
Specifications
| MCU | Xtensa 32-bit LX7 dual-core ESP32S3R8 up to 240MHz dock speed. |
|---|---|
| Memory | PSRAM-8MB, Flash-16MB |
| Display Size | 5" |
| Resolution | 800 × 480 |
| Viewing Angle | IPS Full View |
| Display Colors | 16.7M |
| Communication | 2.4G Wi-Fi (IEEE 802.11 b/g/n) |
| Operating Temperature |
0-60℃ |
| Operating Current | 5V 0.5A (Peak 0.7A) |
| Logic Voltage | 3.3V |
| Bult-in Battery | Enables Panda Touch portable use for up to 0.5 hours. |
| Charging Time | 1.2 hours |
| Expansion Interfaces |
I²C (For temperature/humidity sensors, etc.); USB Drive (For reading USB drives) |
- When using "LAN Only" mode, firmware versions below V1.05.01.00 on the P1P/S will only allow either the Panda Touch or Bambu Studio to connect to the printer at one time. Firmware versions above that will allow both connections simultaneously.
- When using "Cloud" mode, firmware versions below V1.05.01.00 on the P1P/S will allow both Bambu Studio and the Panda Touch to connect simultaneously. However, they will not allow a third device such as Home Assistant to connect, Firmware versions above that will allow all three simultaneous connections.
- MicroSD card and USB drive files can currently only be read from theroot directory and will only be recognized when models are sliced in Build Plate #i in Bambu Studio and are in 3mf format.
- Please check the firmware listing in the product page description to ensurethat your printer firmware is compatible with the Panda Touch, Updating printer firmware to an incompatible version that may limit the functionality of the Panda Touch is not covered under the Warranty.
- When running on its built-in lithium battery, the Panda Touch has abattery life of only 0.5 hours. To maintain the battery and extend the lifespan of the product, it is advised to charge the Panda Touch immediately or turn it off as soon as the battery runs out.
- The screen may flicker when the lithium battery is low on power, This flickering is normal and acts as a warning to users that the battery isalmost empty. Users should then promptly charge the battery or turn off the Panda Touch.
- lf you plan to turn your printer on and off frequently then we recommend running the Panda Touch on USB direct mode. This bypasses the battery and prevents the battery from being taken through many cydes, lf you want to run off the battery then simply flick the switch on the back of the Panda Touch to the battery power mode.
